key features high and stable operating voltage low self-discharge rate (less than 1% after 1 year of storage at + 20?) stainless steel construction hermetic glass-to-metal sealing built-in safety vent non-flammable electrolyte restricted for transport (class 9) typical magnetic signatures: 200 nt (2 mgauss) at 6 mm 10 nt (0.1 mgauss) at 127 mm 3 nt (0.03 mgauss) at 300 mm main applications seismic surveying oceanographic instrumentation buoys scientific equipment etc... optional upon request specific cell terminations multi-cell battery packs september 2004 cell size references um1 ?r20 ?d primary lithium batteries ls 33600lm for magnetism-sensitive applications requesting good voltage response and operating life in - 60?/+ 85? environments. 3.6v primary lithium-thionyl chloride (li-socl 2 ) high energy d-size bobbin cell with low magnetic signature electrical characteristics (typical values relative to cells stored for one year or less at + 30? max.) nominal capacity 17.0 ah (at 5 ma + 20? 2.0v cut off. the capacity restored by the cell varies according to current drain, temperature and cut off). open circuit voltage (at + 20?) 3.67v nominal voltage (at 0.7ma + 20?) 3.6v pulse capability: typically up to 400 ma (400 ma/0.1 second pulses, drained every 2 mn at + 20? from undischarged cells with 10 ? base current, yield voltage readings above 3.0v. the readings may vary according to the pulse characteristics, the temperature, and the cell's previous history. fitting the cell with a capacitor may be recommended in severe conditions. consult saft) continuous current permitting 50% of the nominal capacity to be achieved at + 20? with 2.0v cut off. 250 ma (higher currents possible, consult saft) storage (recommended) + 30? (+ 86?) max (for more severe conditions, consult saft) operating temperature range - 60?/+ 85? (operation above ambient t may lead to reduced capacity and (- 76?/+ 185?) lower voltage readings at the beginning of pulses. consult saft) physical characteristics diameter (max) 33.4 mm (1.32 in) height (max) 60.2 mm (2.37 in) typical weight 90 g (3.2 oz) li metal content approx. 4.5 g
saft 12, rue sadi carnot 93170 bagnolet - france tel +33 1 49 93 19 18 fax +33 1 49 93 19 69 www.saftbatteries.com doc. n o 31039-2-0904 published by the communications department information in this document is subject to change without notice and becomes contractual only after written confirmation by saft. for more details on primary lithium technologies please refer to primary lithium batteries selector guide doc n o 31048-2-0604. photo credit: saft produced by arthur associates soci?t? anonyme au capital de 31 944 000 rcs bobigny b 383 703 873 ls 33600lm storage the storage area should be clean, cool (not exceeding + 30 c), dry and ventilated. warning fire, explosion and severe burn hazard. do not recharge, short circuit, crush, disassemble, heat above 100 c (212 f), incinerate, or expose contents to water. do not solder directly to the cell. 0.1 1 10 100 1000 +55 c -20 c +20 c -40 c 3.6 3.5 3.4 3.3 3.2 3.1 3.0 2.9 2.8 2.7 2.6 2.5 3.5 3.3 3.1 2.9 2.7 2.5 2.3 2.1 1.9 1.7 0.1 1 10 100 1000 10000 15 ohms/200 ma 30 ohms/107 ma 515 ohms/6.9 ma 1000 ohms/3.5 ma 0.1 1 10 100 1000 16.0 14.0 12.0 10.0 8.0 6.0 4.0 2.0 0 +20 c -2 0 c -40 c current (ma) voltage plateau versus current and temperature (at mid-discharge) time (hours) typical discharge profiles at + 20? current (ma) restored capacity versus current and temperature (2.0v cut off) cell voltage (v) cell voltage (v) capacity (ah) dimensions in mm. 33.2 0.2 9.3 0.1 (on flat surface) 18.0 0.2 (on flat surface) 59.6 0.6 0.6 0.2 0.5
|
